Newbie with Churchill cub
#18
So, I looked at the gearing requirements for threading metric and there are 4 gears in the train and I only have three places to mount them. I initially thought perhaps i would mount two gears on one shaft, but then the gears won't reach each other.

The setup needed to be like the picture below

   
Churchill Cub Lathe Mk3a, Dore Westbury Mk1 Mill
Recently retired, new to machining and having loads of fun


Reply
Thanks given by:


Messages In This Thread
Newbie with Churchill cub - by Lockwood1956 - 01-08-2023, 10:16 AM
RE: Newbie with Churchill cub - by EdK - 01-08-2023, 11:21 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 05:26 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 06:36 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 06:39 AM
RE: Newbie with Churchill cub - by Highpower - 01-09-2023, 12:16 PM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 12:43 PM
RE: Newbie with Churchill cub - by EdK - 01-09-2023, 11:23 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 01:02 PM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-09-2023, 01:10 PM
RE: Newbie with Churchill cub - by Highpower - 01-09-2023, 03:48 PM
RE: Newbie with Churchill cub - by EdK - 01-09-2023, 02:11 PM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-11-2023, 07:47 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-10-2023, 02:20 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-10-2023, 02:22 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-10-2023, 02:01 PM
RE: Newbie with Churchill cub - by Dr Stan - 01-10-2023, 06:40 PM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-11-2023, 07:57 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-11-2023, 08:00 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-11-2023, 08:01 AM
RE: Newbie with Churchill cub - by Lockwood1956 - 01-11-2023, 08:02 AM
RE: Newbie with Churchill cub - by EdK - 01-11-2023, 10:37 AM



Users browsing this thread: 2 Guest(s)