07-07-2012, 11:05 AM
Dave, 
then you better start reading the manual thoroughly and provide me with instructions while I use it. 
Thank you, John.
One question: There are 2 ways to move the z axis. Which should I be using?
The drill press like level has a stroke of 55mm. Do I use it if I'm moving less than 55mm?
Regards,
Wong
then you better start reading the manual thoroughly and provide me with instructions while I use it. Thank you, John.
One question: There are 2 ways to move the z axis. Which should I be using?
The drill press like level has a stroke of 55mm. Do I use it if I'm moving less than 55mm? Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.