Accessories & Tools Advice

[stevec]

(07-06-2012, 05:59 PM)Wongster Wrote: Hi Steve,

Are you referring to this para?

Quote:It is not possible to insert a tool or tool holder with internal threads into the work spindle first and to screw the tool retaining/forcing screw into the internal thread afterwards! The tool or tool holder must be screwed onto the tool retaining/forcing screw.

If it is, I read it as having to screw the tool retaining/forcing screw into the spindle first and screw in the tool or tool holder with internal threads M10 onto the tool retaining/forcing screw. The tightening is done using the allen wrench and the retaining bolt (referred to as holding pin in the text while the diagram uses the term retaining bolt) to draw in the tool/tool holder.


Regards,
Wong

That is the paragraph I was referring to. After re-reading it several times I think I understand it. Sorry.