10-29-2022, 03:27 PM
(10-28-2022, 08:31 PM)rubes Wrote: A good tight fit in the bores and your less likely to spill them all over the place when you open it.
I can tell you that bore sizes on the box I got from Ed are spot on. I only had one gage out of the bunch that didn't slide all the way down into the hole. And that was due to a very small burr sticking out from from the cross hole that is drilled through the gage for the wire cable to hold them. Some gentle strokes with a needle file to remove the burr (.001" - .002") and the gage slid right in. That's how close they fit.
One thing I will mention is that the SAE and Metric labels should be reversed. But that is my fault that I didn't catch it earlier. When I sent the hole sizes I needed to Ed, I obviously marked the groups incorrectly.
But I printed some new stick on vinyl labels to put over them and all is good.
Willie