Switched a few times and was always concerned about getting the correct torque. The last time seemed to be fine until I had to turn the heat up to get some PETG to print well. Not a major leak but just enough over several hours to be noticeable.
Decided to switch the hotend to a Revo Six. Just got it installed but initial impression is good. Have a couple different sizes ObXidian on order so wear-n-tear should not be an issue.
Decided to switch the hotend to a Revo Six. Just got it installed but initial impression is good. Have a couple different sizes ObXidian on order so wear-n-tear should not be an issue.