10-26-2022, 07:11 PM
I just changed the nozzle for the first time last night. Should have done it a long time ago.
I was having problems getting prints to stick. Playing with the z offset helped some, but not always. Last night I got a partial clog and decided to check the nozzle. The end was so worn (nearly a full millimeter), that it wasn't anywhere near as close to the bed as I thought.
New nozzle, new bed tramming, and all is right with the printer again.
I was having problems getting prints to stick. Playing with the z offset helped some, but not always. Last night I got a partial clog and decided to check the nozzle. The end was so worn (nearly a full millimeter), that it wasn't anywhere near as close to the bed as I thought.
New nozzle, new bed tramming, and all is right with the printer again.
Full of ideas, but slow to produce parts