10-09-2022, 12:35 PM
Decided I needed a set of soft jaws for the shop vise, and I refuse to pay for them. So, some aluminum angle, a couple of magnets and some sheet rubber. All of which I had laying around the shop. In fact, the rubber and angle were from the scrap bins at work, so free to me.
Rubber was attached to the angles with VHB tape. Magnets were pressed in. Total time about 30 minutes.
Rubber was attached to the angles with VHB tape. Magnets were pressed in. Total time about 30 minutes.
Full of ideas, but slow to produce parts