Latest Delivery

[Highpower]

The bearing puller / installer set arrived. Lots of Chinese grease to clean off before I could measure things but I got it done. The only CAD I can do is cartoon aided drawings... so all I can give you are dimensions I'm afraid.  

   

1)  12mm x 1.5mm x 125mm (Dog Point 8mm dia. x 10mm long)
     Fully Threaded

2)  12mm x 1.5mm x 400mm (Dog Point 8mm dia. x 10mm long)
     Thread Length 300mm

3)  Push Tube: 40mm O.D. x 175mm Length x 32mm I.D.
     One end counter bored to 36mm I.D. x 70 mm Depth

4)  Pull Tube: 45mm O.D., 34.9mm I.D, 91mm depth. OAL 110mm
     Solid end w/ 12mm X 1.5mm threaded center hole.
     Flange: 80.5mm O.D.,  5mm Thickness w/ 16mm radius cut-out. Three 6mm thru holes.

5)  12mm flat washer

6)  12mm x 1.5mm nut

7)  Pull Plate: 37.9mm O.D., 13mm OAL, 13.2mm thru hole.
    Three steps: 30mm O.D. / 22mm O.D. / 19.45mm O.D.
     Each step 1.5mm in height.

8)  Pull Plate: 42mm O.D., 13mm OAL, 13.2mm thru hole.
     1st step: 34.9mm O.D. 2.8mm height.
      2nd step (other side) 30mm O.D. 2mm height.

9)  Push Plate: 30mm O.D., 10mm OAL
     One step 19mm O.D., 3mm height. 8.5mm thru hole.

10)  Push Plate: 42mm O.D., 10mm OAL
       One step 29mm O.D., 3mm height. 8.5 mm thru hole.

11)  Pull Plate: 60.9mm O.D., 13mm OAL, 13.2mm thru hole.
       One step 28.9mm OD., 4.15mm height.
       Outer ring width 5.45mm (Depressed section 50mm I.D.)