MetalworkingFun Forum › Machining › General Metalworking Discussion v
valuable information site

Thread Modes
valuable information site
TOM REED Offline
Junior
****
Posts: 266
Threads: 23
Joined: Feb 2012
Location: OLDS, ALBERTA
#20
07-06-2012, 01:50 AM
Just needed a 3rd party app called overdrive media consol so now works great, very convienient size for in a chair or bed,much larger thanmy smartphone yet smaller than laptop. Sending this reply from the reader. Tom
Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:


Messages In This Thread
valuable information site - by TOM REED - 06-22-2012, 10:34 PM
RE: valuable information site - by ScrapMetal - 06-23-2012, 02:40 AM
RE: valuable information site - by stevec - 06-23-2012, 06:37 AM
RE: valuable information site - by EdK - 06-23-2012, 07:33 AM
RE: valuable information site - by TOM REED - 06-23-2012, 07:44 AM
RE: valuable information site - by stevec - 06-23-2012, 12:50 PM
RE: valuable information site - by Highpower - 06-23-2012, 09:16 AM
RE: valuable information site - by TOM REED - 06-23-2012, 09:46 AM
RE: valuable information site - by Highpower - 06-23-2012, 10:19 AM
RE: valuable information site - by TomG - 06-23-2012, 11:37 AM
RE: valuable information site - by Highpower - 06-23-2012, 01:23 PM
RE: valuable information site - by TomG - 06-23-2012, 02:08 PM
RE: valuable information site - by Tony Wells - 06-23-2012, 11:44 AM
RE: valuable information site - by Highpower - 06-23-2012, 01:14 PM
RE: valuable information site - by EdK - 06-23-2012, 08:30 PM
RE: valuable information site - by Mayhem - 06-23-2012, 09:20 PM
RE: valuable information site - by TOM REED - 06-24-2012, 02:58 AM
RE: valuable information site - by TOM REED - 07-05-2012, 07:09 PM
RE: valuable information site - by EdK - 07-05-2012, 07:28 PM
RE: valuable information site - by TOM REED - 07-06-2012, 01:50 AM
RE: valuable information site - by flutedchamber - 09-07-2012, 11:25 PM



Users browsing this thread: 2 Guest(s)