04-06-2022, 12:54 PM
(04-05-2022, 08:06 PM)EdK Wrote: Pin spanner wrench for the collet blocks and a micrometer stand. Could have used the stand yesterday trying to measure the end of the R8 collets I got. A few of them wouldn't fit into the mill.
Ed
Was the collet issue due to their diameter or due to the alignment pin in the spindle being adjusted in too far?
I know the keyways in my Lyndex collets are a bit more shallow than my Enco collets so they wouldn't fit at first. Eventually I just removed the pin all together after adding the power drawbar. Not sorry.
Willie