HF Bandsaw Dimension
#16
I had to cut a bunch of aluminum pieces for a future project, when the mill arrives. I had added the tray underneath to catch most of the swarf but it was still getting on the floor so I clamped a piece of 3D printed part that was a reject from some project to see if it would help block some of the swarf. It did so I'm going to take some measurements and print up a proper shield.

Ed

   
Reply
Thanks given by:


Messages In This Thread
HF Bandsaw Dimension - by EdK - 05-28-2021, 03:01 AM
RE: HF Bandsaw Dimension - by rleete - 05-28-2021, 07:35 AM
RE: HF Bandsaw Dimension - by rleete - 05-29-2021, 01:10 PM
RE: HF Bandsaw Dimension - by EdK - 05-29-2021, 02:08 PM
RE: HF Bandsaw Dimension - by rleete - 05-29-2021, 02:20 PM
RE: HF Bandsaw Dimension - by EdK - 05-29-2021, 03:24 PM
RE: HF Bandsaw Dimension - by EdK - 12-23-2021, 01:00 PM
RE: HF Bandsaw Dimension - by rleete - 12-23-2021, 01:51 PM
RE: HF Bandsaw Dimension - by EdK - 12-23-2021, 06:04 PM
RE: HF Bandsaw Dimension - by EdK - 12-24-2021, 12:52 PM
RE: HF Bandsaw Dimension - by Highpower - 12-24-2021, 02:15 PM
RE: HF Bandsaw Dimension - by Vinny - 12-24-2021, 02:23 PM
RE: HF Bandsaw Dimension - by EdK - 01-19-2022, 03:38 PM
RE: HF Bandsaw Dimension - by vtsteam - 01-19-2022, 09:24 PM
RE: HF Bandsaw Dimension - by EdK - 01-19-2022, 11:34 PM
RE: HF Bandsaw Dimension - by EdK - 03-04-2022, 02:11 PM
RE: HF Bandsaw Dimension - by EdK - 03-04-2022, 09:20 PM
RE: HF Bandsaw Dimension - by EdK - 03-06-2022, 04:57 PM
RE: HF Bandsaw Dimension - by rleete - 03-06-2022, 05:26 PM
RE: HF Bandsaw Dimension - by Highpower - 03-06-2022, 08:36 PM



Users browsing this thread: 2 Guest(s)