MetalworkingFun Forum › Machining › General Metalworking Discussion v
Needle Files

Thread Modes
Needle Files
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 2 users Like EdK's post:
Highpower (03-03-2022), f350ca (03-03-2022)
#7
03-03-2022, 06:43 PM
Found another pouch of files today while looking for a small, flat file to deburr a bronze bearing I had turned the OD on to fit my milling vise. These have been around for quite a while. Made in Japan.

Ed

         
Reply
Thanks given by:


Messages In This Thread
Needle Files - by EdK - 02-05-2022, 11:26 AM
RE: Needle Files - by Highpower - 02-05-2022, 04:56 PM
RE: Needle Files - by Highpower - 02-06-2022, 08:50 PM
RE: Needle Files - by Dr Stan - 02-06-2022, 10:53 PM
RE: Needle Files - by Highpower - 02-07-2022, 12:14 AM
RE: Needle Files - by Dr Stan - 02-07-2022, 12:53 PM
RE: Needle Files - by EdK - 03-03-2022, 06:43 PM
RE: Needle Files - by Highpower - 03-03-2022, 07:39 PM
RE: Needle Files - by EdK - 03-03-2022, 07:47 PM



Users browsing this thread: 1 Guest(s)