02-28-2022, 05:27 PM
(02-28-2022, 04:44 PM)EdK Wrote:(02-28-2022, 03:51 PM)rleete Wrote: Standard print quality (.2mm layer height) yields a 22.5 hour print, using 170g (about 57 meters) of filament. That's roughly 5 bucks in material.
That's close to what I got out of PrusaSlicer. 21 hours, 11 minutes and 165.5g of filament. I used an infill of 25% where the guy from Thingaverse used 20% He also didn't use any supports but I added supports to those arms that stick up on the back. No way would my printer be able to handle it without supports. I had to learn how to selectively add supports so at least I learned something.
Ed
I'm assuming the supports you guys are talking about are for while it's printing and they are not permanent right?
Willie