01-27-2022, 10:48 PM
I believe he said he already tried that Vinny. But he used a slide hammer rather than a center push bolt.
I wasn't talking about using a typical 2 or 3 jaw bearing/gear puller Darren. I was talking about a bearing separator that has knife edges on the back side to wedge between 2 bearings that are pressed on back to back or flush to a shoulder. Tighter than two coats of paint. The knife edges would easily get enough purchase on the rear taper of your hub to pull it off.
(01-27-2022, 05:00 PM)Mayhem Wrote: I cannot get any grip with a bearing puller, given the taper at the back of the hub.
I wasn't talking about using a typical 2 or 3 jaw bearing/gear puller Darren. I was talking about a bearing separator that has knife edges on the back side to wedge between 2 bearings that are pressed on back to back or flush to a shoulder. Tighter than two coats of paint. The knife edges would easily get enough purchase on the rear taper of your hub to pull it off.
Willie