Clutch issue - Woodhouse and Mitchell Junior 70 lathe

Thread Modes

Help Clutch issue - Woodhouse and Mitchell Junior 70 lathe

Vinny

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

The following 2 users Like Vinny's post:
EdK (01-28-2022), Mayhem (01-28-2022)

#14

01-27-2022, 10:09 PM

You can still use a puller, it doesn't have to grab from behind. Even make one. Piece of steel with 3 holes, center one tapped for a nice bolt. The other two line up with the threaded holes in the hub. Tighten the bolt to pull it off.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Mayhem - 01-07-2022, 07:41 PM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by EdK - 01-07-2022, 07:45 PM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Mayhem - 01-07-2022, 07:59 PM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Highpower - 01-07-2022, 08:08 PM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Mayhem - 01-07-2022, 08:33 PM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Mayhem - 01-27-2022, 06:43 AM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by rleete - 01-27-2022, 07:26 AM

RE: Clutch issue - Woodhouse and Mitchell Junior 70 lathe - by Highpower - 01-27-2022, 09:45 AM