01-27-2022, 09:45 AM
Are we sure those hubs aren't threaded onto the shafts? Hey, I had to ask right?
My first choice (assuming they aren't threaded or pinned on) would be a bearing separator and puller set.
Failing that alone, follow up with an inductive bearing heater or a blue smoke wrench. I agree with rleete - you are probably going to need some thermal expansion happening on those.
Most of the oil ports on my lathe are open as well but considering it's country of origin...
My first choice (assuming they aren't threaded or pinned on) would be a bearing separator and puller set.
Failing that alone, follow up with an inductive bearing heater or a blue smoke wrench. I agree with rleete - you are probably going to need some thermal expansion happening on those.
Most of the oil ports on my lathe are open as well but considering it's country of origin...
Willie