01-21-2022, 08:34 AM
Arise, old thread, and live again!
I just had to cut some Teflon rod for a couple of bushings. I used my wood bandsaw (fairly fine tooth blade) along with the miter gauge. It cut quite cleanly with minimal effort. Cleanup of cut ends was done on the lathe, again with minimal effort.
I just had to cut some Teflon rod for a couple of bushings. I used my wood bandsaw (fairly fine tooth blade) along with the miter gauge. It cut quite cleanly with minimal effort. Cleanup of cut ends was done on the lathe, again with minimal effort.
Full of ideas, but slow to produce parts