Share your prints

[Mayhem]

(01-13-2022, 11:39 AM)Highpower Wrote: Just how big of a printer do you have? They do look good though.  

I've some 105 / 155 ordinance (decommissioned) in my collection as well. Certainly not small in stature nor light weight.  

I think your 'lumpyness' might be caused by the same problem I always have. Camera shake.

I have a CR-10 so the work envelope is pretty big.  However, I design these to screw together and print each part individually.  Here is the drawing for the HE shell and you can see the four individual pieces.  

   

I always make the male thread shorter than the female thread, so that the pieces will screw together without any gaps.

   

Here is the base of the HEAT-T showing the included voids, which reduces the amount of filament used.  I started including this in my large models after I had printed the HE.

   

I think the camera issue had to do with the light and the background, as the other picture came out just fine.