|
No Name Cross Vise
|
|
01-10-2022, 10:56 PM
(01-10-2022, 09:43 PM)EdK Wrote: It's a rare beast though at 5/8-4 thread. I couldn't find that combination anywhere. I went through that with the lead screw in my lathe tail stock. Metric diameter with an imperial pitch.  I just bought a slightly larger diameter of imperial acme rod (standard dimensions) and a new bronze nut and turned them to fit the tail stock.
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
No Name Cross Vise - by EdK - 01-07-2022, 02:27 PM
RE: No Name Cross Vise - by Highpower - 01-07-2022, 03:21 PM
RE: No Name Cross Vise - by EdK - 01-10-2022, 09:43 PM
RE: No Name Cross Vise - by Highpower - 01-10-2022, 10:56 PM
RE: No Name Cross Vise - by EdK - 01-11-2022, 12:14 AM
RE: No Name Cross Vise - by FlingZ - 07-09-2022, 09:11 AM
RE: No Name Cross Vise - by EdK - 07-09-2022, 11:39 AM
|
