MetalworkingFun Forum › Machining › General Shop Stuff v
Wet wheel grinder.

Thread Modes
Wet wheel grinder.
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 2 users Like f350ca's post:
EdK (01-07-2022), Highpower (01-07-2022)
#6
01-07-2022, 05:40 PM
Oh yah, i started sharpening my wood chisels on the surface grinder with a sine plate set to the correct angle. AWSOME edge, a few swipes on a water stone to remove the burr and they're surgically sharpe
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Wet wheel grinder. - by Highpower - 01-07-2022, 01:27 PM
RE: Wet wheel grinder. - by EdK - 01-07-2022, 02:20 PM
RE: Wet wheel grinder. - by Highpower - 01-07-2022, 03:14 PM
RE: Wet wheel grinder. - by rleete - 01-07-2022, 04:27 PM
RE: Wet wheel grinder. - by f350ca - 01-07-2022, 05:36 PM
RE: Wet wheel grinder. - by Highpower - 01-07-2022, 07:51 PM
RE: Wet wheel grinder. - by f350ca - 01-07-2022, 05:40 PM
RE: Wet wheel grinder. - by Dr Stan - 01-08-2022, 03:50 PM
RE: Wet wheel grinder. - by EdK - 01-19-2022, 12:35 PM



Users browsing this thread: 1 Guest(s)