MetalworkingFun Forum › Machining › 3D Printing v
Drying Filament

Thread Modes
Drying Filament
rleete Offline
Senior
*****
Posts: 771
Threads: 48
Joined: Mar 2012
Location: Rochester, NY
The following 1 user Likes rleete's post:
arvidj (08-18-2021)
#9
08-18-2021, 06:08 AM
A warm oven will dry filament just as well as a dedicated dryer. Lots of YouTube videos to guide you.

I keep my filament in these: IRIS USA UCB-SS Weathertight Storage Box, 19 Quart, Clear which I found at multiple places like Target, Walmart, Amazon, etc. I throw in whatever desiccant packs I can find. No problems with moisture at all.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK


Messages In This Thread
Drying Filament - by EdK - 08-09-2021, 02:08 PM
RE: Drying Filament - by arvidj - 08-09-2021, 04:53 PM
RE: Drying Filament - by EdK - 08-09-2021, 05:40 PM
RE: Drying Filament - by arvidj - 08-09-2021, 06:39 PM
RE: Drying Filament - by Vinny - 08-09-2021, 09:14 PM
RE: Drying Filament - by EdK - 08-09-2021, 09:38 PM
RE: Drying Filament - by Vinny - 08-10-2021, 07:13 PM
RE: Drying Filament - by Dr Stan - 08-17-2021, 11:37 AM
RE: Drying Filament - by rleete - 08-18-2021, 06:08 AM
RE: Drying Filament - by EdK - 08-18-2021, 11:28 AM
RE: Drying Filament - by arvidj - 08-18-2021, 06:28 AM
RE: Drying Filament - by Vinny - 08-20-2021, 12:15 PM
RE: Drying Filament - by rleete - 08-18-2021, 09:20 AM
RE: Drying Filament - by EdK - 08-18-2021, 11:40 AM
RE: Drying Filament - by MikeWi - 08-19-2021, 07:21 AM
RE: Drying Filament - by EdK - 08-19-2021, 10:59 AM



Users browsing this thread: 5 Guest(s)