MetalworkingFun Forum › Machining › Projects v
Pulley Puller Adapter

Thread Modes
Pulley Puller Adapter
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
f350ca (07-19-2021)
#10
07-19-2021, 12:27 PM
(07-19-2021, 11:09 AM)rleete Wrote: Where are the jaws?

I took them off while I made the adapter. Made it easier to test the threads I was cutting against the puller piece.

Ed

   
Reply
Thanks given by:


Messages In This Thread
Pulley Puller Adapter - by EdK - 07-14-2021, 12:04 AM
RE: Pulley Puller Adapter - by EdK - 07-14-2021, 03:49 PM
RE: Pulley Puller Adapter - by Pete O - 07-14-2021, 09:19 PM
RE: Pulley Puller Adapter - by EdK - 07-16-2021, 08:30 PM
RE: Pulley Puller Adapter - by Highpower - 07-17-2021, 02:38 AM
RE: Pulley Puller Adapter - by EdK - 07-17-2021, 02:48 AM
RE: Pulley Puller Adapter - by Highpower - 07-17-2021, 01:02 PM
RE: Pulley Puller Adapter - by EdK - 07-19-2021, 10:11 AM
RE: Pulley Puller Adapter - by rleete - 07-19-2021, 11:09 AM
RE: Pulley Puller Adapter - by EdK - 07-19-2021, 12:27 PM
RE: Pulley Puller Adapter - by Dr Stan - 07-22-2021, 09:34 AM



Users browsing this thread: 1 Guest(s)