06-21-2021, 11:07 AM
(06-21-2021, 09:51 AM)rleete Wrote:(06-20-2021, 07:09 PM)EdK Wrote: Printed this tool holder for the most used tools for the mini-lathe. I'll hang it on the wall next to the mini-lathe.
Ed
Wow, nice. You have an .stl file you can share for that?
I sure do. I'll post it later. I need to make some changes to some of the hole diameters for the Allen wrenches and a couple of the center drills. I had to drill them out to get a good fit. Also, it's actually made from two prints. The back panel for hanging the body is a separate piece which is glued and screwed to the back of the body. If I were to do it over I would eliminate the screw by insetting the panel into the body via a dovetail shape. Then it could just be glued to the body.
I can post the FreeCAD file also if you'd like. Then you can make changes if you need to.
Ed