06-10-2021, 08:15 PM
The pulley puller arrived and of course the pointed screw that pushes on the end of the shaft while pulling the pulley off wouldn't fit the bore of the pulley. I had to cut down a 1/2" bolt to the right length to use as a spacer then it came of easy. I can already see a lathe project to fix that problem with the pulley puller.
The motor shaft is keyed but the pulley is not so they just used a set screw in the pulley to lock it into the keyway on the motor shaft.
Ed
The motor shaft is keyed but the pulley is not so they just used a set screw in the pulley to lock it into the keyway on the motor shaft.
Ed