Teflon tips and tricks - got any?
#5
(05-02-2021, 10:15 PM)Hawkeye Wrote: I've cut Teflon with a table saw. Any sharp blade cuts well. Just hold it firmly and control the speed of the cut. Don't want to risk grabbing it and throwing it around the room.

Actually I was concerned about holding it too firmly because it looks like it deforms pretty easily judging from the looks of the corners on the block I got. I suspect it's been dropped a few times in the past. Unknown if that was courtesy of the previous owners handling, the USPS or both.
Willie
Reply
Thanks given by:


Messages In This Thread
Teflon tips and tricks - got any? - by Highpower - 05-02-2021, 03:20 PM
RE: Teflon tips and tricks - got any? - by f350ca - 05-02-2021, 07:11 PM
RE: Teflon tips and tricks - got any? - by Highpower - 05-03-2021, 03:36 AM
RE: Teflon tips and tricks - got any? - by rleete - 01-21-2022, 08:34 AM



Users browsing this thread: 2 Guest(s)