MetalworkingFun Forum › Machining › Plastics & Composites
Hot dip

Thread Modes
Hot dip
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#15
02-22-2021, 10:26 AM
(02-22-2021, 12:08 AM)Highpower Wrote:
(02-10-2021, 11:46 AM)Dr Stan Wrote: I ordered 10 lbs from McMaster-Carr as their price was way below any other supplier. Their web site indicates one pound will cover 3 sq ft at a thickness of .0625 inches.  That works out to 27 cubic inches. So tape measure in hand I calculated my deep fryer would hold 7.4 lbs.  I figure 10 lbs should leave some for my estate sale. Big Grin

So.... how's that working out for you?

I've loaded the fryer with hot dip and it melted just fine.  Been otherwise occupied so I'll plug it in and give it a go today.
Reply
Thanks given by:


Messages In This Thread
Hot dip - by Dr Stan - 02-04-2021, 11:44 AM
RE: Hot dip - by awemawson - 02-04-2021, 12:48 PM
RE: Hot dip - by Highpower - 02-04-2021, 01:48 PM
RE: Hot dip - by Dr Stan - 02-05-2021, 03:29 PM
RE: Hot dip - by Dr Stan - 02-05-2021, 03:32 PM
RE: Hot dip - by Highpower - 02-05-2021, 03:48 PM
RE: Hot dip - by awemawson - 02-05-2021, 03:54 PM
RE: Hot dip - by Dr Stan - 02-08-2021, 12:19 AM
RE: Hot dip - by Dr Stan - 02-08-2021, 09:37 AM
RE: Hot dip - by Vinny - 02-08-2021, 09:09 PM
RE: Hot dip - by Dr Stan - 02-10-2021, 11:46 AM
RE: Hot dip - by Highpower - 02-22-2021, 12:08 AM
RE: Hot dip - by Dr Stan - 02-22-2021, 10:26 AM
RE: Hot dip - by Pete O - 02-11-2021, 02:50 AM
RE: Hot dip - by awemawson - 02-11-2021, 09:19 AM
RE: Hot dip - by Highpower - 02-22-2021, 01:20 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 03:25 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 07:13 PM
RE: Hot dip - by Highpower - 02-22-2021, 08:19 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 11:34 PM
RE: Hot dip - by awemawson - 02-23-2021, 07:44 AM
RE: Hot dip - by Dr Stan - 02-23-2021, 10:26 AM
RE: Hot dip - by Vinny - 02-26-2021, 10:08 PM



Users browsing this thread: 5 Guest(s)