|
Holt Engine (maybe)
|
02-13-2021, 11:33 AM
(02-13-2021, 08:28 AM)haroldmulder Wrote: Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see. I agree. At first glance it all appeared to be a single block (no pun intended) of aluminum until I noticed the screw heads. That is quite a fit!
Willie
Thanks given by: f350ca
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Holt Engine (maybe) - by f350ca - 01-05-2021, 09:06 PM
RE: Holt Engine (maybe) - by Highpower - 01-06-2021, 09:39 AM
RE: Holt Engine (maybe) - by f350ca - 01-06-2021, 10:02 AM
RE: Holt Engine (maybe) - by Highpower - 01-06-2021, 09:47 PM
RE: Holt Engine (maybe) - by f350ca - 01-06-2021, 09:50 PM
RE: Holt Engine (maybe) - by f350ca - 01-09-2021, 08:24 PM
RE: Holt Engine (maybe) - by TomG - 01-10-2021, 11:23 AM
RE: Holt Engine (maybe) - by f350ca - 01-10-2021, 01:44 PM
RE: Holt Engine (maybe) - by f350ca - 02-12-2021, 10:36 PM
RE: Holt Engine (maybe) - by TomG - 02-13-2021, 01:07 AM
RE: Holt Engine (maybe) - by Highpower - 02-13-2021, 02:03 AM
RE: Holt Engine (maybe) - by haroldmulder - 02-13-2021, 08:28 AM
RE: Holt Engine (maybe) - by Highpower - 02-13-2021, 11:33 AM
RE: Holt Engine (maybe) - by f350ca - 02-13-2021, 09:36 AM
|
