MetalworkingFun Forum › Machining › Projects v
Holt Engine (maybe)

Thread Modes
Holt Engine (maybe)
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#13
02-13-2021, 09:36 AM
Thanks Harold,
I added two 1/8 dowel pins to locate the halves, The sides were machined after assembly, but the ends mated up after machining each piece.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Holt Engine (maybe) - by f350ca - 01-05-2021, 09:06 PM
RE: Holt Engine (maybe) - by Highpower - 01-06-2021, 09:39 AM
RE: Holt Engine (maybe) - by f350ca - 01-06-2021, 10:02 AM
RE: Holt Engine (maybe) - by Highpower - 01-06-2021, 09:47 PM
RE: Holt Engine (maybe) - by f350ca - 01-06-2021, 09:50 PM
RE: Holt Engine (maybe) - by f350ca - 01-09-2021, 08:24 PM
RE: Holt Engine (maybe) - by TomG - 01-10-2021, 11:23 AM
RE: Holt Engine (maybe) - by f350ca - 01-10-2021, 01:44 PM
RE: Holt Engine (maybe) - by f350ca - 02-12-2021, 10:36 PM
RE: Holt Engine (maybe) - by TomG - 02-13-2021, 01:07 AM
RE: Holt Engine (maybe) - by Highpower - 02-13-2021, 02:03 AM
RE: Holt Engine (maybe) - by haroldmulder - 02-13-2021, 08:28 AM
RE: Holt Engine (maybe) - by Highpower - 02-13-2021, 11:33 AM
RE: Holt Engine (maybe) - by f350ca - 02-13-2021, 09:36 AM



Users browsing this thread: 3 Guest(s)