MetalworkingFun Forum › Machining › Plastics & Composites
Hot dip

Thread Modes
Hot dip
awemawson Offline
Junior
****
Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK
#13
02-11-2021, 09:19 AM
Crocell (at least) is far more than just a waxy plastic coating - it carries a fair amount of an oily substance.

I have bags of plastic injection moulding pellets as I used to make my own 'machinable wax' - paraffin wax with HDPE melted into it - and that sets up pretty hard without the oily nature of Crocell.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
Hot dip - by Dr Stan - 02-04-2021, 11:44 AM
RE: Hot dip - by awemawson - 02-04-2021, 12:48 PM
RE: Hot dip - by Highpower - 02-04-2021, 01:48 PM
RE: Hot dip - by Dr Stan - 02-05-2021, 03:29 PM
RE: Hot dip - by Dr Stan - 02-05-2021, 03:32 PM
RE: Hot dip - by Highpower - 02-05-2021, 03:48 PM
RE: Hot dip - by awemawson - 02-05-2021, 03:54 PM
RE: Hot dip - by Dr Stan - 02-08-2021, 12:19 AM
RE: Hot dip - by Dr Stan - 02-08-2021, 09:37 AM
RE: Hot dip - by Vinny - 02-08-2021, 09:09 PM
RE: Hot dip - by Dr Stan - 02-10-2021, 11:46 AM
RE: Hot dip - by Highpower - 02-22-2021, 12:08 AM
RE: Hot dip - by Dr Stan - 02-22-2021, 10:26 AM
RE: Hot dip - by Pete O - 02-11-2021, 02:50 AM
RE: Hot dip - by awemawson - 02-11-2021, 09:19 AM
RE: Hot dip - by Highpower - 02-22-2021, 01:20 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 03:25 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 07:13 PM
RE: Hot dip - by Highpower - 02-22-2021, 08:19 PM
RE: Hot dip - by Dr Stan - 02-22-2021, 11:34 PM
RE: Hot dip - by awemawson - 02-23-2021, 07:44 AM
RE: Hot dip - by Dr Stan - 02-23-2021, 10:26 AM
RE: Hot dip - by Vinny - 02-26-2021, 10:08 PM



Users browsing this thread: 1 Guest(s)