01-10-2021, 09:39 AM
(01-10-2021, 12:32 AM)Dr Stan Wrote: Turn down the shank of the reamer or bore the hole.
That’s good to know. I didn’t realize I could turn the shank down. For some reason I thought it would be hardened.
As for boring the cylinder out, my boring bars suck. I haven’t had any luck getting a good finish with them yet. Definitely wouldn’t be a good enough finish for a cylinder and piston.
But I will try turning the shank down.
Trevor
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO