The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Reamer

Thread Modes
Reamer
Cross Slide Offline
Sophmore
***
Posts: 109
Threads: 24
Joined: Aug 2016
Location: Regina Saskatchewan Canada
#1
01-10-2021, 12:00 AM (This post was last modified: 01-10-2021, 12:00 AM by Cross Slide.)
I bought a set of plans for building a model steam engine. The whole project uses all round, Square, and flat CRS and Brass. That is what got me interested in it. As I have most of the supplies already. After looking over and reading the plans I found that I need a 1” Reamer for the Cylinder Bore. I looked into a 1” reamer and found that the shank is 3/4”. My biggest chuck is 5/8”. 

What are my options for getting the bore of the cylinder to spec if I can’t get a reamer that fits my chuck? The design of the cylinder is also a blind hole. 

Trevor
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
Reply
Thanks given by:


Messages In This Thread
Reamer - by Cross Slide - 01-10-2021, 12:00 AM
RE: Reamer - by Dr Stan - 01-10-2021, 12:32 AM
RE: Reamer - by Cross Slide - 01-10-2021, 09:39 AM
RE: Reamer - by TomG - 01-10-2021, 10:40 AM
RE: Reamer - by Cross Slide - 01-10-2021, 12:06 PM
RE: Reamer - by TomG - 01-10-2021, 12:45 PM
RE: Reamer - by Dr Stan - 01-10-2021, 11:15 AM
RE: Reamer - by Cross Slide - 01-10-2021, 12:09 PM
RE: Reamer - by Dr Stan - 01-10-2021, 02:11 PM
RE: Reamer - by f350ca - 01-10-2021, 09:27 PM
RE: Reamer - by rleete - 01-11-2021, 09:43 AM
RE: Reamer - by Highpower - 01-11-2021, 10:46 AM



Users browsing this thread: 1 Guest(s)