01-02-2021, 01:37 PM
Something to consider is using a heat sink that covers a majority of the blade made from either aluminum or copper as both have much higher coefficients of conductivity than steel.
|
Help filling tiny gap
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Help filling tiny gap - by James Riley - 01-01-2021, 12:03 PM
RE: Help filling tiny gap - by f350ca - 01-01-2021, 05:30 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:10 PM
RE: Help filling tiny gap - by Dr Stan - 01-01-2021, 06:16 PM
RE: Help filling tiny gap - by Hawkeye - 01-01-2021, 11:38 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:37 PM
RE: Help filling tiny gap - by Dr Stan - 01-02-2021, 01:37 PM
|
Users browsing this thread: 1 Guest(s)