|
Help filling tiny gap
|
01-01-2021, 06:16 PM
I highly recommend going to anvilfire.com and posting your question in the Guru's Den. Before I gave up blacksmithing due to numerous hand surgeries I was a member and the folks there are some of the most knowledgeable and helpful metal workers you'll ever find. Lots of knife makers on the forum so you should get some excellent advise.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Help filling tiny gap - by James Riley - 01-01-2021, 12:03 PM
RE: Help filling tiny gap - by f350ca - 01-01-2021, 05:30 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:10 PM
RE: Help filling tiny gap - by Dr Stan - 01-01-2021, 06:16 PM
RE: Help filling tiny gap - by Hawkeye - 01-01-2021, 11:38 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:37 PM
RE: Help filling tiny gap - by Dr Stan - 01-02-2021, 01:37 PM
|
