pin vice

[krv3000]

hi all once a gane went to the boot sale and i got two more drills for 20p each and i got a pin vice for 20p so this was my next project i disassemble it as much as possible the threaded bolt is beyond reaper so a new one will be made then placed the lot in me acid bathe after a long sock all was removed and given a good scrub in ruining water then a buff up with a wire brush i had to mack up a new bolt this will have a m8 thread SOS no pics of the next bit i drilled out the wing nut two 10.5mm i then drilled and taped m8 in the end of a Peace of steel rod then turned that dawn to just under 10.5mm to fit in to the wing nut and silver soldered it in place right pics