Two post lift

[Dr Stan]

                       
I have started the process of installing my Nussbaum German designed and built car lift.  It has absolutely minimum usage and shows zero wear on the cylinder rods.  One side down and one to go.  The installation manual I received from Nussbaum shows a different bottom plate (rectangular) than the model I have.  Consequently I am raising the posts, attaching the cross bar then getting everything plumb and square so I can take measurements and cut holes in the concrete floor that will match up.  Built the "movers dollys" using 10 inch (250mm) casters four of which I'll eventually re-purpose as all terrain casters for my scaffolding.  If you noticed the block and tackle I used it to raise the chain hoist to the needed height.