ER25 vs ER32 ?

[henryarnold]

(07-01-2012, 03:02 PM)DanH Wrote:

(07-01-2012, 12:39 PM)henryarnold Wrote: Guys,

Thanks. Here's the MT4 - ER40 Chuck I bought. I used a 11" x 5/8" black oxide bolt with a a custom shoulder washer I made as my draw bar it works great. I mounted a 3/4" piece of drill rod in a 3/4" collet and found the run-out on my setup was +/-0.00025. I think that is very good for a $50 chuck.



If you need an ER chuck for mill or lathe, the EBay seller I purchased from sells ER25, ER32, ER40 chucks and collets.
http://www.ebay.com/itm/330497192569?ssP...1497.l2649

I checked out that e-bay seller and their address is in my area, just across the river from Portland Oregon. I am going to see if they sell local as it will save me the shipping fees. Thanks for the heads up Henry.

The same dealer also has the ER40 wrench for $13. Here's my complete setup. It cost me $80. It does have one disadvantage over Ed's chuck pictured earlier. You can only grip short stock while Ed's chuck will allow you to feed long bar stock through the chuck.