Help Printing Problem
#4
I loaded it into Simplify3d, flipped its back via a 90 degree rotate on the X axis and then sliced it. Looks fine. 491 layers at a .15mm layer setting.

If you want to send me the parameters I can send you the gcode. I only saw it was PLA and .15mm in the page you showed. I'd need temperatures, etc. Or you can take pot-luck with the Inland PLA settings that I use.
Reply
Thanks given by:


Messages In This Thread
Printing Problem - by EdK - 07-28-2020, 12:55 PM
RE: Printing Problem - by arvidj - 07-28-2020, 04:39 PM
RE: Printing Problem - by EdK - 07-28-2020, 06:30 PM
RE: Printing Problem - by arvidj - 07-28-2020, 07:01 PM
RE: Printing Problem - by EdK - 07-29-2020, 09:29 AM
RE: Printing Problem - by arvidj - 07-29-2020, 10:05 AM
RE: Printing Problem - by EdK - 07-29-2020, 12:23 PM
RE: Printing Problem - by EdK - 07-29-2020, 02:21 PM
RE: Printing Problem - by EdK - 07-29-2020, 04:03 PM
RE: Printing Problem - by EdK - 07-29-2020, 07:58 PM
RE: Printing Problem - by Vinny - 07-29-2020, 09:38 PM
RE: Printing Problem - by arvidj - 07-29-2020, 09:57 PM
RE: Printing Problem - by Vinny - 07-30-2020, 11:27 AM
RE: Printing Problem - by EdK - 07-30-2020, 01:08 AM
RE: Printing Problem - by EdK - 07-30-2020, 01:17 PM
RE: Printing Problem - by Vinny - 07-31-2020, 11:05 PM
RE: Printing Problem - by EdK - 08-12-2020, 04:06 PM
RE: Printing Problem - by arvidj - 08-14-2020, 09:39 AM
RE: Printing Problem - by EdK - 08-14-2020, 09:55 AM



Users browsing this thread: 8 Guest(s)