07-28-2020, 12:55 PM
I'm having a problem printing something I drew up in FreeCAD. When I go to print it the printer prints an area in the middle that is not part of the design. Any ideas would be much appreciated.
Ed
This picture shows the section in the middle that shouldn't be printing. The printer crashes into it when it does another layer over the whole surface.
These two pictures are the top and bottom of the FreeCAD design that shows there isn't any square section in the middle that should be printed.
These two pictures are the top and bottom of the slicer design the shows there isn't any square section in the middle that should be printed.
Slice settings showing no brims or supports are included in the printing.
Ed
This picture shows the section in the middle that shouldn't be printing. The printer crashes into it when it does another layer over the whole surface.
These two pictures are the top and bottom of the FreeCAD design that shows there isn't any square section in the middle that should be printed.
These two pictures are the top and bottom of the slicer design the shows there isn't any square section in the middle that should be printed.
Slice settings showing no brims or supports are included in the printing.