MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machining 4140

Thread Modes
Machining 4140
Cross Slide Offline
Sophmore
***
Posts: 109
Threads: 24
Joined: Aug 2016
Location: Regina Saskatchewan Canada
#11
07-04-2020, 11:07 PM
(07-04-2020, 11:01 PM)EdK Wrote: You're getting a good finish.  Smiley-signs107  Thumbsup

Ed

Thanks Ed
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
Reply
Thanks given by:


Messages In This Thread
Machining 4140 - by Cross Slide - 07-03-2020, 03:44 PM
RE: Machining 4140 - by Dr Stan - 07-03-2020, 07:37 PM
RE: Machining 4140 - by Cross Slide - 07-04-2020, 09:28 AM
RE: Machining 4140 - by EdK - 07-04-2020, 10:40 AM
RE: Machining 4140 - by Cross Slide - 07-04-2020, 10:58 AM
RE: Machining 4140 - by f350ca - 07-04-2020, 06:24 PM
RE: Machining 4140 - by Dr Stan - 07-04-2020, 08:42 PM
RE: Machining 4140 - by Cross Slide - 07-04-2020, 10:49 PM
RE: Machining 4140 - by Cross Slide - 07-04-2020, 10:54 PM
RE: Machining 4140 - by EdK - 07-04-2020, 11:01 PM
RE: Machining 4140 - by Cross Slide - 07-04-2020, 11:07 PM
RE: Machining 4140 - by Pete O - 07-05-2020, 05:53 AM
RE: Machining 4140 - by Cross Slide - 07-05-2020, 11:09 AM



Users browsing this thread: 1 Guest(s)