06-27-2020, 05:17 AM
Hi all,
This week I get the test bar into the colchester lathe to check the headstock alignment, and also check the Covmac lathe. Some finishing off on the Socome welder, and then onto the Toro wheelhors tractor to continue the new transmission set up, , Friday afternoon, went to help Keith do a tip run and didn't get home till 8-00, hence this video being uploaded on Saturday! I'll explain the disaster next week!
Phil, Scorching East Yorkshire!
https://youtu.be/RHbXXpY7jTE
This week I get the test bar into the colchester lathe to check the headstock alignment, and also check the Covmac lathe. Some finishing off on the Socome welder, and then onto the Toro wheelhors tractor to continue the new transmission set up, , Friday afternoon, went to help Keith do a tip run and didn't get home till 8-00, hence this video being uploaded on Saturday! I'll explain the disaster next week!
Phil, Scorching East Yorkshire!
https://youtu.be/RHbXXpY7jTE
Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?