06-19-2020, 01:02 AM
Now it's back to the serious stuff, making piston rings.
Just turn a tube of Iron a little oversize.
Split it lengthwise to create the ring gap.
Clamp it in the chuck tightly to close the gap.
Turn the ring to size inside and out.,
Part off.
26mm diameter--- 1.5mm wide---1mm thick.
There now that was simple wasn't it ?????
Brian.
Just turn a tube of Iron a little oversize.
Split it lengthwise to create the ring gap.
Clamp it in the chuck tightly to close the gap.
Turn the ring to size inside and out.,
Part off.
26mm diameter--- 1.5mm wide---1mm thick.
There now that was simple wasn't it ?????
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
http://briansworkshop.weebly.com