MetalworkingFun Forum › Machinery › Other Machinery › Surface Grinders
$100.00

Thread Modes
$100.00
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
The following 1 user Likes Hawkeye's post:
arvidj (06-10-2020)
#4
06-06-2020, 10:11 PM
It's for truing the abrasive wheel on a surface grinder. You can set it up for level, angled or accurate curves on the wheel. I found one (a bit bigger) at my favourite junkers some years ago.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by: arvidj


Messages In This Thread
$100.00 - by Dr Stan - 06-06-2020, 03:47 PM
RE: $100.00 - by Highpower - 06-06-2020, 08:22 PM
RE: $100.00 - by arvidj - 06-06-2020, 09:00 PM
RE: $100.00 - by Hawkeye - 06-06-2020, 10:11 PM
RE: $100.00 - by Dr Stan - 06-06-2020, 11:36 PM
RE: $100.00 - by Pete O - 06-07-2020, 11:45 PM
RE: $100.00 - by Dr Stan - 06-08-2020, 01:42 PM



Users browsing this thread: 2 Guest(s)