05-12-2020, 12:35 PM
(This post was last modified: 05-12-2020, 12:36 PM by Don.
Edit Reason: all words didnt post
)
Willie,
Thanks again for another idea. Have you used one of these? Here again, I see why this "may not work" on my cases. And, again. I may not be looking at it properly. I'm actually machining the 20mm primer out and wanting to wind up with a primer pocket of .3125. Not sure how that could be accomplished with the neat tool you found. Please understand, there is no way to use a primer removal tool to punch the factory 20mm primer out. No centered hole in the primer pocket which goes into the case interior because of the boxer primer. There are 2 smaller holes on either side of the anvil. This falls into the nothing that's hard is ever easy, I think.
Thanks again,
Don
Thanks again for another idea. Have you used one of these? Here again, I see why this "may not work" on my cases. And, again. I may not be looking at it properly. I'm actually machining the 20mm primer out and wanting to wind up with a primer pocket of .3125. Not sure how that could be accomplished with the neat tool you found. Please understand, there is no way to use a primer removal tool to punch the factory 20mm primer out. No centered hole in the primer pocket which goes into the case interior because of the boxer primer. There are 2 smaller holes on either side of the anvil. This falls into the nothing that's hard is ever easy, I think.
Thanks again,
Don