05-10-2020, 11:28 AM
(05-09-2020, 11:56 AM)Don Wrote: Primer is .317/.318 O.D so this would result in proper press fit, I believe.
Don
So you are reaming out belted rifle cases to stuff .50BMG primers into them? Is that it?
Willie
|
Help Machining Question
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Machining Question - by Don - 05-04-2020, 03:41 PM
RE: Machining Question - by f350ca - 05-04-2020, 05:19 PM
RE: Machining Question - by TomG - 05-04-2020, 06:31 PM
RE: Machining Question - by EdK - 05-04-2020, 09:39 PM
RE: Machining Question - by Highpower - 05-05-2020, 12:48 PM
RE: Machining Question - by Vinny - 05-05-2020, 08:37 PM
RE: Machining Question - by Don - 05-09-2020, 11:56 AM
RE: Machining Question - by Highpower - 05-10-2020, 11:28 AM
RE: Machining Question - by Don - 05-09-2020, 01:15 PM
RE: Machining Question - by EdK - 05-09-2020, 03:47 PM
RE: Machining Question - by TomG - 05-09-2020, 11:21 PM
RE: Machining Question - by Don - 05-10-2020, 01:34 PM
RE: Machining Question - by Don - 05-10-2020, 11:48 PM
RE: Machining Question - by Highpower - 05-11-2020, 07:59 PM
RE: Machining Question - by awemawson - 05-11-2020, 02:00 AM
RE: Machining Question - by Don - 05-11-2020, 10:48 AM
RE: Machining Question - by Don - 05-12-2020, 12:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 02:11 PM
RE: Machining Question - by Don - 05-12-2020, 04:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 08:16 PM
|
Users browsing this thread: 1 Guest(s)