MetalworkingFun Forum › Machining › Gunsmithing v
Boring tapered hole

Thread Modes
Boring tapered hole
Paulc Offline
Sophmore
***
Posts: 51
Threads: 11
Joined: Jan 2019
Location: HUMBOLDT, AZ
#27
02-27-2020, 03:19 PM
The traditional recommendation is for a 360 gr bullet and 45 gr of black powder.
Bullet diameter around .558" . Ready cast ones from S&S firearms are listed as .54 cal.
Reply
Thanks given by:


Messages In This Thread
Boring tapered hole - by Paulc - 01-18-2020, 03:34 PM
RE: Boring tapered hole - by Highpower - 01-18-2020, 08:24 PM
RE: Boring tapered hole - by TomG - 01-19-2020, 09:38 AM
RE: Boring tapered hole - by SLK001 - 01-19-2020, 10:06 AM
RE: Boring tapered hole - by Highpower - 01-19-2020, 01:02 PM
RE: Boring tapered hole - by Paulc - 01-19-2020, 04:01 PM
RE: Boring tapered hole - by Highpower - 01-19-2020, 04:37 PM
RE: Boring tapered hole - by Paulc - 01-19-2020, 08:39 PM
RE: Boring tapered hole - by TomG - 01-19-2020, 09:24 PM
RE: Boring tapered hole - by Paulc - 01-20-2020, 02:05 PM
RE: Boring tapered hole - by TomG - 01-20-2020, 03:27 PM
RE: Boring tapered hole - by Paulc - 01-21-2020, 02:42 PM
RE: Boring tapered hole - by Paulc - 01-21-2020, 09:51 PM
RE: Boring tapered hole - by Vinny - 01-22-2020, 09:38 AM
RE: Boring tapered hole - by Paulc - 01-22-2020, 03:00 PM
RE: Boring tapered hole - by Dr Stan - 02-23-2020, 05:46 PM
RE: Boring tapered hole - by Paulc - 02-23-2020, 03:57 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 06:22 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 06:45 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 07:31 PM
RE: Boring tapered hole - by Paulc - 02-23-2020, 08:01 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-24-2020, 01:58 PM
RE: Boring tapered hole - by Paulc - 02-24-2020, 03:13 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-25-2020, 02:14 PM
RE: Boring tapered hole - by Paulc - 02-25-2020, 03:44 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-27-2020, 02:24 PM
RE: Boring tapered hole - by Paulc - 02-27-2020, 03:19 PM
RE: Boring tapered hole - by Paulc - 02-27-2020, 03:28 PM



Users browsing this thread: 4 Guest(s)