02-05-2020, 06:12 AM
(02-04-2020, 09:50 PM)SteveG Wrote: I'm sure I'll end up going back to look at Fusion360 again, and hopefully will make more sense once I've got a few concepts already in my head.
How do the change gears hold up to actual use?
Steve
The change gears I made have performed as asked, though I haven't used the a lot. I also used Fusion 360 to design and print a custom banjo for fine feed. The fine feed banjo holds dedicated gears. I think the gears are 20t and 90t.
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.