The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Clamp type knurling tool question.
#1
I can't seem to figure this one out, so please splain it to me.

What is the difference between a LH / Center / or RH tool shank on a knurling tool?
From this diagram it looks like the only difference is where the pivot point is in relation to the tool shank. Either above, centered or below the center height of the shank. How does that change what 'hand' the tool is. I don't get it. What am I missing?  Smiley-think005

I could see if the knurl wheels were located on one side of the tool or the other, but they all look like the sit in the center of the jaws/tool body.

   
Willie
Reply
Thanks given by:


Messages In This Thread
Clamp type knurling tool question. - by Highpower - 01-27-2020, 05:06 AM
RE: Clamp type knurling tool question. - by TomG - 01-27-2020, 08:51 AM



Users browsing this thread: 2 Guest(s)