01-07-2020, 07:35 PM
(01-07-2020, 07:32 PM)Cross Slide Wrote: Thanks Ed.
I definitely like the look of the one that uses the inserts. Don’t know if it’s out of my league or not. I would have to figure out how to cut the dovetails.
But that’s definitely what I’m looking for!!
Trevor
Yea, the Holescreek one is considered one of the best ball turners you can find plans for. Don't worry about cutting the dovetails. It's not as scary as you might think. Just post questions on the forum. We have a lot of experienced machinists on this forum that are more than happy to help.
Ed