Looking for Ball Turning Plans

Thread Modes

Looking for Ball Turning Plans

Cross Slide Offline

Sophmore

Posts: 109
Threads: 24
Joined: Aug 2016
Location: Regina Saskatchewan Canada

01-06-2020, 07:05 PM

(01-06-2020, 09:55 AM)rleete Wrote: I built the one from plans provided on HMEM, I believe. It is the one that has a round base, and mounts to the cross slide.

After further searching, it is the Steve Bedair design from http://bedair.org/Ball/ball.html

Works very well, I just don't use it much.

Thanks for the info

Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Looking for Ball Turning Plans - by Cross Slide - 01-05-2020, 09:29 PM

RE: Looking for Ball Turning Plans - by Dr Stan - 01-05-2020, 11:46 PM

RE: Looking for Ball Turning Plans - by rleete - 01-06-2020, 09:55 AM

RE: Looking for Ball Turning Plans - by Cross Slide - 01-06-2020, 07:05 PM

RE: Looking for Ball Turning Plans - by EdK - 01-06-2020, 10:54 AM

RE: Looking for Ball Turning Plans - by Cross Slide - 01-06-2020, 07:06 PM

RE: Looking for Ball Turning Plans - by EdK - 01-07-2020, 12:05 AM