MetalworkingFun Forum › Machinery › Lathes v
Atlas TH42

Thread Modes
Atlas TH42
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#12
12-31-2019, 01:05 PM
DO NOT put a pin through that bronze bushing!!!

The bushing is supposed to be a press fit inside the bore of the gear housing. It is not supposed to come out. The pin should go through the shaft and the gear body only so that the shaft can turn inside the bushing.
Willie
Reply
Thanks given by:


Messages In This Thread
Atlas TH42 - by impman76 - 12-28-2019, 12:31 PM
RE: Atlas TH42 - by Highpower - 12-28-2019, 02:38 PM
RE: Atlas TH42 - by EdK - 12-28-2019, 02:46 PM
RE: Atlas TH42 - by impman76 - 12-28-2019, 05:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 05:01 AM
RE: Atlas TH42 - by Highpower - 12-30-2019, 12:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 02:47 PM
RE: Atlas TH42 - by Highpower - 12-30-2019, 03:58 PM
RE: Atlas TH42 - by Dr Stan - 12-30-2019, 07:24 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 11:26 AM
RE: Atlas TH42 - by Highpower - 12-31-2019, 01:05 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 01:43 PM
RE: Atlas TH42 - by Highpower - 12-31-2019, 02:41 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 05:22 PM
RE: Atlas TH42 - by Dr Stan - 01-05-2020, 03:49 PM
RE: Atlas TH42 - by Highpower - 01-05-2020, 08:09 PM



Users browsing this thread: 1 Guest(s)